DIY : Make your own video out cable from the extUSB ear plugs

DIY Video Out Cable for Windows Mobile HTC

You will need:

1. One Red White and Yellow RCA Cable
2. Ear plugs extUSB
3. Free time

Modder’s Instructions :

• Remove pin four from the extUSB plug. *note this can be tricky but is necessary to allow the device to recognise the cable as a TV out cable as opposed to a Headset cable. I used a needle to bend into the middle of the plug and then used a tiny micro screwdriver to bend backwards and forwards until it broke. Be careful not to damage any of the other contacts. [ Step 1 Image ]
• Cut cable as close to mic piece as possible and remove outside cover. [ Step 2 Image ]
• Solder the following pairs of cables together using the following codes: [ Step 3 Image ]
  1. Video positive (Yellow RCA end) –> White pvc coated cable (extUSB end).
  2. Video sheild (Yellow RCA end), –> blue copper cable (extUSB end).
  3. Audio Left (White or Black RCA end) –> green copper cable (extUSB end).
  4. Audio Right (Red RCA end) –> red copper cable (extUSB end).
  5. Audio Sheild ( both Red and White or Black RCA end –> copper cable (extUSB end), * note the copper cable is the sheild wire that surounds all the coloured wires.
  6. The last two colored copper wires
• Wrap electrical tape around the solderd wires so that they do not touch any of the other contacts. [ Step 4 Image ]
• Plug in and play. [ Step 5 Image ]

dont forget to say thanks to audible_paradigm in his thread